Latest NSE7_SDW-7.0 Pass Guaranteed Exam Dumps with Accurate & Updated Questions
NSE7_SDW-7.0 Exam Brain Dumps - Study Notes and Theory
NEW QUESTION # 31
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic does not match any of the entries in the policy route table.
- B. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- C. The sdwan_service_id flag in the session information is 0.
- D. All SD-WAN rules have the default setting enabled.
Answer: A,C
Explanation:
sdwan_service_id is 0 = match SD-WAN implicit rule, study guide 7.0 page 120, 7.2 page 149 SD-WAN rules internally are interpreted as a Policy route, so when the traffic doesn't match with any policy route, it will be flowing by implict policy.
NEW QUESTION # 32
Refer to the exhibit.
The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)
- A. ibgp-multipath is disabled.
- B. additional-path is enabled.
- C. Each BGP route is three hops away from the destination.
- D. You can run the get router info routing-table database command to display the additional paths.
Answer: B,D
NEW QUESTION # 33
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. holdtime-timer
- B. set-route-tag
- C. update-source
- D. link-down-failover
Answer: A,D
NEW QUESTION # 34
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. mode-cfg must be enabled.
- B. add-route must be disabled.
- C. type must be set to static.
- D. exchange-interface-ip must be enabled.
Answer: B
Explanation:
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 35
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
- A. Host 8.8.8.8 is reachable through port1 and port2.
- B. FortiGate removes all static routes for port2.
- C. Port2 becomes alive after three successful probes are detected.
- D. The administrator manually restores the static routes for port2, if port2 becomes alive.
Answer: B
Explanation:
Explanation
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead
NEW QUESTION # 36
Which two statements about SD-WAN central management are true? (Choose two.)
- A. It supports normalized interfaces for SD-WAN member configuration.
- B. It uses templates to configure SD-WAN on managed devices.
- C. It does not support meta fields.
- D. The objects are saved in the ADOM common object database.
Answer: B,D
Explanation:
Explanation
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-
NEW QUESTION # 37
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Specify a unique peer ID for each dial-up VPN interface.
- B. Use unique Diffie Hellman groups on each VPN interface.
- C. Configure the IKE mode to be aggressive mode.
- D. Use different proposals are used between the interfaces.
Answer: A,C
NEW QUESTION # 38
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Changes have been made on firewall policy ID 1 on FortiGate.
- B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- C. Firewall policy ID 1 has source NAT disabled.
- D. FortiGate has terminated the session after a change on policy ID 1.
Answer: A
NEW QUESTION # 39
Which two statements about SD-WAN central management are true? (Choose two.)
- A. It supports normalized interfaces for SD-WAN member configuration.
- B. It uses templates to configure SD-WAN on managed devices.
- C. It does not support meta fields.
- D. The objects are saved in the ADOM common object database.
Answer: B,D
Explanation:
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-fmg
NEW QUESTION # 40
Refer to the exhibit.
Based on the exhibit, which action does FortiGate take?
- A. FortiGate bounces port5 after it detects all SD-WAN members as dead.
- B. FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.
- C. FortiGate brings down port5 after it detects all SD-WAN members as dead.
- D. FortiGate brings up port5 after it detects all SD-WAN members as alive.
Answer: B
NEW QUESTION # 41
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)
- A. FortiGate evaluates new sessions.
- B. FortiGate terminates the old sessions.
- C. FortiGate does not change existing sessions.
- D. FortiGate flushes all sessions.
Answer: A,C
Explanation:
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 42
Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.
What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?
- A. You must enable net-device.
- B. You must enable auto-discovery-sender.
- C. You must set ike-version to 1.
- D. You must disable idle-timeout.
Answer: A
NEW QUESTION # 43
Refer to the exhibit.
Based on the output, which two conclusions are true? (Choose two.)
- A. There is more than one SD-WAN rule configured.
- B. The SD-WAN rules take precedence over regular policy routes.
- C. The all_rules rule represents the implicit SD-WAN rule.
- D. Entry 1(id=1) is a regular policy route.
Answer: A,D
NEW QUESTION # 44
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure advanced CLI settings.
- B. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- C. You can reference meta fields.
- D. You can configure interfaces as SD-WAN members without having to remove references first.
Answer: A,C
NEW QUESTION # 45
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
- B. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
- C. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
- D. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
Answer: B
NEW QUESTION # 46
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
- A. icmp
- B. twamp
- C. dns
- D. http
Answer: C,D
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
NEW QUESTION # 47
Refer to the exhibits.
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- B. London generates an IKE information message that contains the Toronto public IP address.
- C. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- D. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
Answer: A,D
NEW QUESTION # 48
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan health-check
- B. diagnose sys sdwan sla-log
- C. diagnose sys sdwan log
- D. diagnose sys sdwan intf-sla-log
Answer: B
Explanation:
SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.
NEW QUESTION # 49
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic does not match any of the entries in the policy route table.
- B. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- C. The sdwan_service_id flag in the session information is 0.
- D. All SD-WAN rules have the default setting enabled.
Answer: A,C
NEW QUESTION # 50
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)
- A. Port2 has the highest member priority.
- B. Port2 has a lower latency than port1.
- C. FortiGate updated the outgoing interface list on the rule so it prefers port2.
- D. SD-WAN rule ID 1 is set to lowest cost (SLA) mode.
Answer: B,C
NEW QUESTION # 51
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- B. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- C. It acts as a policy compliance entity to review all managed FortiGate devices.
- D. It improves SD-WAN performance on the managed FortiGate devices.
- E. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
Answer: A,E
NEW QUESTION # 52
In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose two.)
- A. It enables spokes to establish shortcuts to third-party gateways.
- B. It enables spokes to bypass the hub during shortcut negotiation.
- C. It provides direct connectivity between spokes by creating shortcuts.
- D. It provides the benefits of a full-mesh topology in a hub-and-spoke network.
Answer: C,D
NEW QUESTION # 53
Which components make up the secure SD-WAN solution?
- A. Telephone, ISDN, and telecom network.
- B. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- C. Application, antivirus, and URL, and SSL inspection
- D. Datacenter, branch offices, and public cloud
Answer: B
NEW QUESTION # 54
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. mode-cfg must be enabled.
- B. add-route must be disabled.
- C. type must be set to static.
- D. exchange-interface-ip must be enabled.
Answer: B
Explanation:
Explanation
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 55
......
Fortinet NSE7_SDW-7.0 exam is an important certification for IT professionals who work with SD-WAN technology. NSE7_SDW-7.0 exam covers a range of topics related to Fortinet's products and services and is designed to test the knowledge and skills of candidates in this area. Fortinet NSE 7 - SD-WAN 7.0 certification can help IT professionals to demonstrate their expertise and advance their career prospects.
Pass Fortinet NSE7_SDW-7.0 Test Practice Test Questions Exam Dumps: https://examsboost.actualpdf.com/NSE7_SDW-7.0-real-questions.html
